PERFORMANCE ENHANCEMENT OF BRASS EDM ELECTRODES WITH CRYOGENIC TREATMENT WHILE MACHINING THE COLD WORK STEEL AISI D2
Abstract
This study investigates the performance of deep cryogenically treated brass (CuZn25Al5) electrodes in the die-sink EDM process. Two different cryogenic treatment durations, 6 h and 12 h, were applied to 8 mm diameter electrodes, and their effects were compared to untreated electrodes. The machining tests were conducted under moderate and aggressive conditions. In the machining tests, the 6-h cryo-treated electrode exhibited a 16.8% increase in material removal rate (MRR) under moderate conditions and a 19.7% increase under aggressive conditions compared to the reference electrode. The 12-h cryo-treated electrode showed similar MRR values to the reference electrode but improved tool wear resistance by 9.4% under moderate conditions. The kerf angle was minimized, indicating better hole verticality, in the 6-h cryo-treated electrode group. The improvement in machining performance was attributed to the enhancement in electrical conductivity of the electrodes, which increased by 28% for the 6-h cryo-treated electrode and 20% for the 12-h cryo-treated electrode. X-ray diffraction (XRD) analysis revealed shifts in peak positions and possible phase transformations due to cryogenic treatment. Surface roughness measurements showed improved surface conditions in the cryo-treated electrodes under aggressive conditions. The results indicate that cryogenic treatment enhances MRR, reduces tool wear, and improves surface quality in die-sink EDM. These improvements are attributed to increased electrical conductivity and changes in the internal structure of the brass electrode.