Skip main navigation

Cookies Notification

We use cookies on this site to enhance your user experience. By continuing to browse the site, you consent to the use of our cookies. Learn More
×

System Upgrade on Tue, May 28th, 2024 at 2am (EDT)

Existing users will be able to log into the site and access content. However, E-commerce and registration of new users may not be available for up to 12 hours.
For online purchase, please visit us again. Contact us at customercare@wspc.com for any enquiries.

SEARCH GUIDE  Download Search Tip PDF File

  • articleNo Access

    A MIXED-SIGNAL ROW/COLUMN ARCHITECTURE FOR VERY LARGE MONOLITHIC mm-WAVE PHASED ARRAYS

    The range of mm-wave radio communications is severely constrained by high losses arising from the short wavelength and from atmospheric attenuation. Large phased arrays can overcome these limitations, but it is very difficult to realize them using present monolithic beamsteering IC architectures. We propose an alternative architecture for large monolithic phased arrays. The beam is steered in altitude and in azimuth by separately imposing vertical and horizontal phase gradients. This choice reduces IC complexity, making large arrays feasible. Since extensive digital processing provides robust amplitude control and reduces die area, the LOs are processed as digital signals. Being very sensitive to compression, the IF signals are processed as analog signals and distributed by means of synthetic transmission-line buses. With careful frequency planning, this mixed-signal approach can allow large phased arrays to operate at frequencies much higher than those achievable with pure analog design.

  • articleNo Access

    MILLIMETER WAVE TO TERAHERTZ IN CMOS

    The feasibility of CMOS circuits operating at frequencies in the upper millimeter wave and low sub-millimeter frequency regions has been demonstrated. A 140-GHz fundamental mode VCO in 90-nm CMOS, a 410-GHz push-push VCO in 45-nm CMOS, and a 180-GHz detector circuit in 130-nm CMOS have been demonstrated. With the continued scaling of MOS transistors, 1-THz CMOS circuits will be possible. Though these results are significant, output power of signal generators must be increased and acceptable noise performance of detectors must be achieved in order to demonstrate the applicability of CMOS for implementing practical terahertz systems.