Vibration Behavior of Composite Cold-Formed Steel Floors with Concrete Topping due to Heel-Drop Loading
Abstract
Human-induced vibration is an important serviceability issue of modern structural designs, especially for light long-span structures. The common heel-drop impact is usually considered in evaluating the vibration of cold-formed steel (CFS) floors. This paper proposes a simplified equation for determining the peak accelerations under transient impacts, based on the Duhamel integral. The analytical results were validated with a comparison with the results from the heel-drop test results on a CFS floor of 3 900mm × 5 600mm (at both construction and completion stages). The dynamic responses of the floor, including peak acceleration, maximum transient vibration value (MTVV), and crest factor (a ratio of MTVV-to-peak acceleration) were analyzed in detail. The natural frequencies of the floor were obtained from the FFT and FRF analysis of heel-drop and hammering test results. The investigated on-site composite CFS floor with concrete topping was found to have a high fundamental frequency: 17Hz at the construction stage and 21Hz at the completion stage. In determining the fundamental frequency of the CFS floor, the hammering was thought to be more effective than the heel-drop owing to the phenomenon of human-structure interaction (HSI). Moreover, finite element analyses were performed to study the effects of profiled steel sheeting type (Types 28-100-800, 21-180-900, and 14-80-640) and concrete thickness (40, 50, 60, 70, 80, 90, and 100mm). With the SCSC condition (two opposite edges clamped and the other two edges simply-supported), the peak acceleration decreased by 50% when the concrete thickness increased from 40mm to 100mm.
| Remember to check out the Most Cited Articles! |
|---|
|
Remember to check out the structures |
