Narrow Results

The p-silicon surfaces have been irradiated with ~ 100 MeV Si⁷⁺ions to a fluence of 2.2×10¹³ ions cm^-2, and surface morphology has been studied with atomic force microscopy (AFM). Interesting features of cracks of ~ 47 nm in depth and ~ 103 nm in width on the irradiated surfaces have been observed. The observed features seemed to have been caused by the irradiation-induced stress in the irradiated regions of the target surface.

Laser cladding is one kind of advanced surface modification technology and has the abroad prospect in making the wear-resistant coating on metal substrates. However, the application of laser cladding technology does not achieve the people's expectation in the practical production because of many defects such as cracks, pores and so on. The addiction of rare earth can effectively reduce the number of cracks in the clad coating and enhance the coating wear-resistance. In the paper, the effects of rare earth on metallurgical quality, microstructure, phase structure and wear-resistance are analyzed in turns. The preliminary discussion is also carried out on the effect mechanism of rare earth. At last, the development tendency of rare earth in the laser cladding has been briefly elaborated.

Serious microcracks often occur on the surface of nanohydroxyapatite (n-HAP) artificial bone scaffolds prepared by selective laser sintering (SLS) technology. In this study, we found that appropriate preheating before sintering can reduce and attenuate the cracks. The microstructure and morphology of sintered n-HAP were tested at different preheating temperature and laser sintering speed with scanning electron microscopy (SEM), X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FT-IR). The experiments showed that the cracks gradually reduced and then disappeared when the preheating temperature increased from 0°C to 600°C while other parameters remain unchanged. The n-HAP particles gradually fused and grew up, while the grain size of sintered n-HAP will be attenuated with the increase of preheating temperature. As the thermal conductivity of n-HAP increases with increased preheating temperature, the temperature drops quickly, inhibiting greatly the grain growth of n-HAP. We obtained a group of optimum parameters when the sintered n-HAP still maintains nanostructure and possesses the optimal comprehensive performances, that is, laser power is 26 W, spot diameter is 4 mm, sintering speed is 200 mm/min, layer thickness is 0.4 mm, layer density is 852 kg/m³, and optimized preheating temperature is 600°C. These data illustrated that the cracks of sintered n-HAP can be eliminated at appropriate preheating temperature and sintering speed. This provided experimental optimal condition for the preparation of artificial bone scaffolds with nanohydroxyapatite ceramics.