Narrow Results

This study aims to predict the long-term behavior of fiber-reinforced plastic (FRP) or steel plates externally strengthening RC two-way slabs using ANSYS software non-linear finite element (FE) modeling and making a comparison between the FE analysis with the experimental test results, in addition, calculated the effect of parameters on the strengthened slab behavior: compressive strength, the magnitude of sustained load, slab length to slab thickness, and the external strengthening type. The Prony series were used in the model of non-linear viscoelastic in this paper to study the deflection of time-dependent adopted. The modeling was done to solve the problems of the creep by the FEs by ANSYS software, the results showed an acceptable agreement level with the results of the experiment. The parametric study’s numerical results indicate that as sustained load increases for 20–60% Pu kN, the time-dependent deflection increases by around 2.5 times, as well as a decrease in the long-term efficiency of the slabs that external strengthening where the deflection is increased due to increased creep, and the effect creep has on the deflection.

Plastics is commonly used in consumer electronics because of it is high strength per unit mass and good productivity, but plastic components may often become distorted after injection molding due to residual stress after the filling, packing, and cooling processes. In addition, plastic deteriorates depending on various temperature conditions and the operating time, which can be characterized by stress relaxation and creep. The viscoelastic behavior of plastic materials in the time domain can be expressed by the Prony series using the ABAQUS commercial software package. This paper suggests a process for predicting post-production deformation under cyclic thermal loading. The process was applied to real plastic panels, and the deformation predicted by the analysis was compared to that measured in actual testing, showing the possibility of using this process for predicting the post-production deformation of plastic products under thermal loading.

Elastomers or rubber-like materials exhibit nonlinear viscoelastic behavior such as creep and relaxation upon mechanical loading. Differential constitutive models and hereditary integrals are the main frameworks followed in the literature for modeling the viscoelastic behavior at finite deformations. Regular differential operators can be replaced by fractional-order derivatives in the standard models in order to make fractional viscoelastic models. In the present paper, the relaxation behavior of elastomers is formulated both in terms of ordinary (integer-order) and fractional differential viscoelastic models. The derived constitutive equations are fitted to several experimental data to compare their efficiency in modeling the stress relaxation phenomenon. Specifically, a fractional viscoelastic model with one fractional dashpot (FD) is compared with two ordinary models including respectively one and two ordinary dashpots (OD). The models are compared in fitting accuracy, number of required material parameters and also variation of parameters from one compound to another to clarify the effects of filler content and deformation rate. It is shown that, the results of the ordinary model with one OD is not good at all. The fractional model with one FD and the ordinary model with two ODs provide good fittings for all compounds whereas the former uses only three parameters and the latter uses five material parameters. For the fractional model, the order of the Maxwell element and the associated relaxation time approximately remain the same for different compounds of each material at certain loading rates, but it is not the case for the ordinary differential models.

Plastics is commonly used in consumer electronics because of it is high strength per unit mass and good productivity, but plastic components may often become distorted after injection molding due to residual stress after the filling, packing, and cooling processes. In addition, plastic deteriorates depending on various temperature conditions and the operating time, which can be characterized by stress relaxation and creep. The viscoelastic behavior of plastic materials in the time domain can be expressed by the Prony series using the ABAQUS commercial software package. This paper suggests a process for predicting post-production deformation under cyclic thermal loading. The process was applied to real plastic panels, and the deformation predicted by the analysis was compared to that measured in actual testing, showing the possibility of using this process for predicting the post-production deformation of plastic products under thermal loading.